How about that shooter who lives in the country? Just carefully clean the barrel as best as you can, unless it had other unusual problems like havening been neglected. Pistol grip stock and any number of options were available for the 94 at different times in it's production.. Mostly it is a matter of the OAL of your ammo. Check the screw hold- Correct sight picture.
It's a short little fellow and easy to lose. The hammer only travels to the dropped posi- tion momentarily after the trigger has been pulled with 10 the hammer cocked. Might be more than you want? On da Bayou Teche Posts: I use a Lyman Magdriver which comes with seven hollow-ground bits in its handle.
What is the best way to clean and maintain my Winchester Model 94, made in ?
I must say, I like the 'Tear Down' option on the model If there is no indentation, your gun has malfunctioned and should be serviced by a qualified gunsmith. It was a straight shooter and I loved it. Open the action and remove all cartridges from the magazine, chamber and action areas. Mud, snow, and an infinite variety of other obstructions may inadvertently lodge in a barrel bore.
Never load in the house or in your vehicle. The 4 screws we will remove are numbered in the order in which we will remove them. Loading the tubular magazine was fast and fumble-free, and I then hunkered down behind my MTM Predator rifle rest to see if the little Winchester could do what needed to be done. When I clean the 94 I do it with the breach down so cleaners do not drip into the action. I've had mine since and have not taken it apart.